Exhaust Pipes

Are you confused about how exhaust X pipes are measured? You’re not alone. Many car enthusiasts and DIY mechanics find themselves scratching their heads over whether these pipes are measured by inside diameter. Understanding this can make a big difference in how your vehicle performs. Getting it wrong might mean reduced efficiency and possible damage…

If your exhaust pipe falls off, it is important to take action immediately. Driving without an exhaust pipe can be extremely dangerous as poisonous gases can enter the car and cause serious health problems. If you are able to, pull over to the side of the road and call a tow truck or mechanic. If…

If you have a rust problem with your exhaust pipe, there are a few things that you can do to remove the rust and get your pipe back to normal. The first thing that you can do is to sand the affected area down with some fine-grit sandpaper. This will help to remove any of…

The H-pipe in an exhaust system is used to balance the air flow between the left and right sides of the engine. It is placed between the two banks of cylinders, with each bank having its own exhaust pipe. The H-pipe helps to equalize the pressure between the two sides of the engine, which can…

Yes, you can braze exhaust pipe. In order to do so, you will need a torch and some brazing rod. First, heat up the area that you want to braze. Then, touch the brazing rod to the heated area and allow it to melt. Once the brazing rod has melted, it will form a bond…

The LS1 exhaust manifold bolt size is 3/8-16. If you’re looking to upgrade your LS1 exhaust manifold, you’ll need to know the correct bolt size. The LS1 exhaust manifold uses a M8 x 1.25 bolts, so make sure you pick up the right size when shopping for an upgrade. While you’re at it, consider upgrading…

The ls exhaust manifold bolt torque is 65 ft-lbs. Make sure to use a torque wrench when tightening these bolts. If you don’t have a torque wrench, you can use a socket and ratchet to tighten the bolts, but make sure not to overtighten them. Exhaust manifolds are one of the most important parts of…

In 2019, General Motors issued a recall for certain vehicles with 3.6L V6 engines due to an issue with the exhaust manifold bolts. The recall affected Chevrolet Silverado 1500, GMC Sierra 1500, and Cadillac CTS models from the 2014-2018 model years. GM issued the recall after discovering that some of the affected vehicles had bolts…

The location of the exhaust gas temperature sensor is in the exhaust system, before the catalytic converter. The purpose of this sensor is to measure the temperature of the exhaust gases. This information is used by the engine control module to adjust the air/fuel mixture and timing of the ignition. An Exhaust Gas Temperature Sensor,…